Installation manual

Self assemble plastic feed container

Cut a hole in the bottom of the feeder bin - approximately 100mm in diameter.
Attach the unit to the feed bin using the 4 bolts supplied.
Connect feed shoot angle adapter to aluminum neck under bin.
Measure how long you need plastic feeder shute and cut with hand saw.

---

Solar Panel
Attach to holding bin near lid where screw holes are placed.
Or place solar panel on fence facing sun.

Connect lead into electric box under bin.
​
Battery – connect terminals to 12 volt battery.

---

Timer
 Set as per Timer Manual

---

​Feeder testing
Run machine for one minute into a container and weigh on kitchen scales to give you correct feed per minute.
Feed should be easy flowing pellets or grains.
Set timer to suit feed requirements.

---

Troubleshooting
Check Battery connection
Check Battery charge
Check Overload switch

​Ring Ken for further assistance 0418 330 148